HPE2-W09 Exam Dumps - Try Best HPE2-W09 Exam Questions from Training Expert DumpsValid
Practice Examples and Dumps & Tips for 2021 Latest HPE2-W09 Valid Tests Dumps
NEW QUESTION 21
Is this a way that a data center technology can help meet requirements for multi-tenancy?
Solution: Virtual Extensible LAN (VXLAN) enables multiple isolated Layer 3 domains, each with its own routing table, to share a physical network.
- A. No
- B. Yes
Answer: A
NEW QUESTION 22
Refer to the exhibits.
Is this how the switch handles the traffic?
Solution: A broadcast arrives in VLAN 10 on Switch-1. Switch 1 forwards the frame on all interfaces assigned to VLAN10, except the incoming interface. It encapsulates the broadcast with VXIAN and sends it to 192.168.1.2. but not 192.168.1.3.
- A. No
- B. Yes
Answer: B
NEW QUESTION 23
Is this correct positioning of AtubaOS-CX switches in the data center?
Solution: Aruba CX 6300 switches are an appropriate choice for leaf switches in a leaf-spine topology that uses Virtual Extensible LAN (VXLAN) with Ethernet VPN (EVPN).
- A. No
- B. Yes
Answer: A
NEW QUESTION 24
Is this a requirement for implementing Priority Flow Control (PFC) on an ArubaOS-CX switch interface?
Solution: configuring trust of Cos on the interface
- A. No
- B. Yes
Answer: B
NEW QUESTION 25
Refer to the exhibit.
You want to enable devices in VRF B and VRF C to reach shared resources in VRFA.
is this a valid strategy for meeting this goal?
Solution: Create a separate OSPF process for each VRF on Switch-1. Then redistribute each process into the other VRFs' processes.
- A. No
- B. Yes
Answer: A
NEW QUESTION 26
Your customer is using Nutanix AHV and they need a network orchestration tool to simplify network provisioning. Is this operation supported when Aruba Fabric Composer (AFC) is integrated with Nutanix?
Solution: Automated configuration of Layer 3 MP-BGP protocol on leaf switches
- A. No
- B. Yes
Answer: A
NEW QUESTION 27
You need to integrate Aruba Fabric Composer (AFC) with customer datacenter software. Is this integration possible?
Solution: Aruba Fabric Composer (AFC) with Nutanix Hypervisor (AHV)
- A. No
- B. Yes
Answer: A
NEW QUESTION 28
You are using NetEdit to manage AruDaOS-CX switches. You want to deploy a standard config to the switches, but need the config to include a few device-specific settings such as hostname and IP address.
Is this what you should do?
Solution: Inside a configuration plan, light-click any device-specific parameters and modify the parameter per-device.
- A. No
- B. Yes
Answer: A
NEW QUESTION 29
Two ArubaOS-CX switches ate part of a Virtual Switching Extension (V5X) fabric. Is this a guideline for configuring the switches' link-up delay settings?
Solution: Set the link-up delay timer based on the number of MAC forwarding, ARP, and routing table entries.
- A. No
- B. Yes
Answer: A
NEW QUESTION 30
Is this statement about ARP and ND Suppression true?
Solution: Both ARP-Suppression and ND-Suppression are disabled by default.
- A. No
- B. Yes
Answer: A
NEW QUESTION 31
Is this a way that a data center technology can help meet requirements for multi-tenancy?
Solution: Virtual Extensible LAN (VXLAN) provides millions of IDs to scale for the needs of a multi-tenant environment
- A. No
- B. Yes
Answer: A
NEW QUESTION 32
Is this part of the process for using NetEdit to update firmware on ArubaOS-CX switches?
Solution: Use a firmware update plan to manage both updating the Image on selected devices and reboot.
- A. No
- B. Yes
Answer: A
NEW QUESTION 33
You are using NetEdit to manage AruDaOS-CX switches. You want to deploy a standard config to the switches, but need the config to include a few device-specific settings such as hostname and IP address.
Is this what you should do?
Solution: omit the device-specific settings from the configuration plan and include them in command scripts instead.
- A. No
- B. Yes
Answer: A
NEW QUESTION 34
An ArubaOS-CX is \ssmq DCBX on Interface 1/1/1. You enter this command:
show dcbx interface 1/1/1
Is this where you can see whether the connected converged network adapter (CNA) has accepted the application priorities advertised with DCBX?
Solution: in the Enhanced Transmission Selection (ETS) Local advertisement section
- A. No
- B. Yes
Answer: B
NEW QUESTION 35
Is this a use case for deploying Ethernet Ring Protection Switching (ERPS)?
Solution: extending Layer 2 communications between data centers that connect over Layer 3 MPLS links
- A. No
- B. Yes
Answer: A
NEW QUESTION 36
You want to use NetEdit to configure an AtubaOS-CX switch.
Is this a minimum requirement for setting up communications between the switch and NetEdit?
Solution: Make sure that the SSH server is enabled.
- A. No
- B. Yes
Answer: B
NEW QUESTION 37
Refer to the exhibit.
You are adding a VLAN 30, subnet 10.0.30.0/24 to the network shown in the exhibit. (This network is simplified to just the relevant switches for this item.) This subnet belongs in VRF A, and you have added a Layer 3 VLAN 30 interface attached to this VRF on Switch-1. You want to make the services in this VLAN available to devices in 10.1.20.0/24 in VRF B.
Is this part of a valid setup for meeting these requirements?
Solution: Add a route with this command: ip route 10.1.20.0/24 vlan20 vrf A
- A. No
- B. Yes
Answer: A
NEW QUESTION 38
Your customer is using Nutanix AHV and they need a network orchestration tool to simplify network provisioning. Is this operation supported when Aruba Fabric Composer (AFC) is integrated with Nutanix?
Solution: Automated provisioning of LAGs Between AHV and VSX
- A. No
- B. Yes
Answer: A
NEW QUESTION 39
Is this a use case for disabling split-recovery mode on ArubaOS-CX switches in a Virtual Switching Extension (VSX) fabric?
Solution: You are not concerned about split Drain Issues in your environment, so you want the secondary member to keep its links up if the ISL falls.
- A. No
- B. Yes
Answer: B
NEW QUESTION 40
Refer to the exhibit.
Refer to the exhibit.
You are adding a VLAN 30, subnet 10.0.30.0/24 to the network shown in the exhibit. (This network is simplified to just the relevant switches for this item.) This subnet belongs in VRF A, and you have added a Layer 3 VLAN 30 interface attached to this VRF on Switch-1. You want to make the services in this VLAN available to devices in 10.1.20.0/24 in VRF B.
Is this part of a valid setup for meeting these requirements?
Solution: Add VRF B as the secondary VRF on VLAN interface 30.
- A. No
- B. Yes
Answer: A
NEW QUESTION 41
Refer to the exhibits.
Is this how the switch-1 handles the traffic?
Solution: A broadcast arrives in VLAN 10 on Switch-1. Switch 1 forwards the frame on all interfaces assigned to VLAN 10, except the incoming interface. It encapsulates the broadcast with VXIAN and sends it to 192.168.1.3, out not 192.168.1.2.
- A. No
- B. Yes
Answer: B
NEW QUESTION 42
Refer to the exhibits.
Is this how the switch handles the traffic?
Solution: A frame with destination MAC address, 00:50:56:15:16:28, arrives with a VLAN 10 tag on 1/1/1 on Switch-1. Switch-1 encapsulates the frame with VXLAN and an IP header destined to 192.168.1.2.
- A. No
- B. Yes
Answer: A
NEW QUESTION 43
Is this a best practice when positioning ArubaOS-CX switches in data center networks?
Solution: Deploy Aruba CX 6300 switches as data center spine switches.
- A. No
- B. Yes
Answer: B
NEW QUESTION 44
Is this how you should position switches in the ArubaOS-CX portfolio tor data center networks?
Solution: Deploy Aruba 83xx switches as data center leaf switches.
- A. No
- B. Yes
Answer: B
NEW QUESTION 45
......
HP HPE2-W09 Exam Syllabus Topics:
| Topic | Details |
|---|---|
| Topic 1 |
|
| Topic 2 |
|
| Topic 3 |
|
| Topic 4 |
|
| Topic 5 |
|
| Topic 6 |
|
Latest 100% Passing Guarantee - Brilliant HPE2-W09 Exam Questions PDF: https://www.dumpsvalid.com/HPE2-W09-still-valid-exam.html
HPE2-W09 Certification – Valid Exam Dumps Questions Study Guide: https://drive.google.com/open?id=1Yt8O-d2DGi2A4v6QrSvAofm5ZIIefTQs