Course 2025 NSE6_FNC-7.2 Test Prep Training Practice Exam Download
NSE6_FNC-7.2 Exam Info and Free Practice Test Professional Quiz Study Materials
NEW QUESTION # 22
During the on-boarding process through the captive portal, what are two reasons why a host that successfully registered would remain stuck in the Registration VLAN? (Choose two.)
- A. The wrong agent is installed.
- B. There is another unregistered host on the same port.
- C. The port default VLAN is the same as the Registration VLAN.
- D. Bridging is enabled on the host.
Answer: B,C
NEW QUESTION # 23
What would happen if a port was placed in both the Forced Registration and the Forced Remediation port groups?
- A. Only al-risk hosts would be impacted.
- B. Both types of enforcement would be applied.
- C. Only rogue hosts would be impacted.
- D. Both enforcement groups cannot contain the same port.
Answer: D
NEW QUESTION # 24
Which three are components of a security rule? (Choose three.)
- A. Action
- B. User or host profile
- C. Trigger
- D. Methods
- E. Security String
Answer: A,B,C
Explanation:
Components of a security rule in FortiNAC include:
* Trigger: The condition or event that initiates the evaluation of the rule.
* User or Host Profile: A requirement that can be added to a rule to specify the user or host profile that must be matched.
* Action: The activities or responses that FortiNAC performs when the rule is matched.
References
* FortiNAC 7.2 Study Guide, page 419
NEW QUESTION # 25
What would occur if both an unknown (rogue) device and a known (trusted) device simultaneously appeared on a port that is a member of the Forced Registration port group?
- A. The port would be administratively shut down.
- B. The port would not be managed, and an event would be generated.
- C. The port would be provisioned for the normal state host, and both hosts would have access to that VLAN.
- D. The port would be provisioned to the registration network, and both hosts would be isolated.
Answer: D
Explanation:
When a rogue device connects to a port in the Forced Registration port group, FortiNAC's response is to isolate that device by moving it to a registration captive network. This is part of FortiNAC's state-based control mechanism, where the system acts based on the state of the device (normal, rogue, etc.) and the group or port it is connected to. In this specific scenario, the focus is on the isolation of the rogue device, and the guide does not explicitly detail the simultaneous handling of the normal device.
References: FortiNAC 7.2 Study Guide, State-Based Control section.
NEW QUESTION # 26
Which two methods can be used to gather a list of installed applications and application details from a host? (Choose two)
- A. Portal page on-boarding options
- B. MDM integration
- C. Application layer traffic inspection
- D. Agent technology
Answer: A,C
NEW QUESTION # 27
Which connecting endpoints are evaluated against all enabled device profiling rules?
- A. All hosts, each time they connect
- B. Known trusted devices each time they change location
- C. Rogues devices, only when they connect for the first time
- D. Rogues devices, each time they connect
Answer: D
NEW QUESTION # 28
An administrator wants the Host At Risk event to generate an alarm. What is used to achieve this result?
- A. An event to action mapping
- B. An event to alarm mapping
- C. A security trigger activity
- D. A security filter
Answer: B
NEW QUESTION # 29
An administrator wants the Host At Risk event to generate an alarm. What is used to achieve this result?
- A. An event to action mapping
- B. An event to alarm mapping
- C. A security trigger activity
- D. A security filter
Answer: B
Explanation:
To generate an alarm from a Host At Risk event, an administrative user must create an Event to Alarm Mapping for the Vulnerability Scan Failed event. Within this alarm mapping, a host security action must be designated to mark the host at risk
NEW QUESTION # 30
Which two things must be done to allow FortiNAC to process incoming syslog messages from an unknown vendor? (Choose two.)
- A. The device must be added as a patch management server.
- B. The device sending the messages must be modeled in the Network Inventory view.
- C. The device must be added as a log receiver.
- D. A security event parser must be created for the device.
Answer: B,D
Explanation:
To allow FortiNAC to process incoming syslog messages from an unknown vendor, two steps must be taken:
* Creation of a customized event parser: This enables FortiNAC to parse and integrate syslog messages from any vendor or device, as long as the messages are in CSV, CEF, or Tag/Value format.
* Modeling the device in the Topology view: Any device that sends syslog messages to FortiNAC must be modeled in this view. FortiNAC will not process syslog or trap messages unless the source address belongs to a device modeled in the topology.
References
* FortiNAC 7.2 Study Guide, pages 428 and 399
NEW QUESTION # 31
How are logical networks assigned to endpoints?
- A. Through FortiGate IPv4 policies
- B. Through Layer 3 polling configurations
- C. Through device profiling rules
- D. Through network access policies
Answer: D
NEW QUESTION # 32
Which three communication methods are used by the FortiNAC to gather information from, and control, infrastructure devices? (Choose three)
- A. OSNMP
- B. FTP
- C. DCLI
- D. RADIUS
- E. SMTP
Answer: B,C,E
NEW QUESTION # 33
In a wireless integration, how does FortiNAC obtain connecting MAC address information?
- A. MAC notification traps
- B. End station traffic monitoring
- C. RADIUS
- D. Link traps
Answer: A
NEW QUESTION # 34
An administrator is configuring FortiNAC to manage FortiGate VPN users. As part of the configuration, the administrator must configure a few FortiGate firewall policies.
What is the purpose of the FortiGate firewall policy that applies to unauthorized VPN clients?
- A. To deny access to only the FortiNAC VPN interface
- B. To deny access to only the production DNS server
- C. To allow access to only the FortiNAC VPN interface
- D. To allow access to only the production DNS server
Answer: C
NEW QUESTION # 35
What would occur if both an unknown (rogue) device and a known (trusted) device simultaneously appeared on a port that is a member of the Forced Registration port group?
- A. The port would be administratively shut down.
- B. The port would be provisioned for the normal state host, and both hosts would have access to that VLAN.
- C. The port would not be managed, and an event would be generated.
- D. The port would be provisioned to the registration network, and both hosts would be isolated.
Answer: B
NEW QUESTION # 36
What causes a host's state to change to "at risk"?
- A. The host has been administratively disabled.
- B. The logged on user is not found in the Active Directory.
- C. The host is not in the Registered Hosts group.
- D. The host has failed an endpoint compliance policy or admin scan.
Answer: D
Explanation:
Failure - Indicates that the host has failed the scan. This option can also be set manually. When the status is set to Failure the host is marked "At Risk" for the selected scan.
NEW QUESTION # 37
Where are logical network values defined?
- A. In the security and access field of each host record
- B. In the port properties view of each port
- C. On the profiled devices view
- D. In the model configuration view of each infrastructure device
Answer: D
NEW QUESTION # 38
Where do you look to determine when and why the FortiNAC made an automated network access change?
- A. The Port Changes view
- B. The Admin Auditing view
- C. The Event view
- D. The Connections view
Answer: A
Explanation:
Reference:
Study Guide p. 356: Any time FortiNAC changes network access for an endpoint, the change is documented on the Port Changes view. This provides an administrator with valuable information when validating control configurations and enforcement.
NEW QUESTION # 39
......
Fortinet NSE6_FNC-7.2 Exam Syllabus Topics:
| Topic | Details |
|---|---|
| Topic 1 |
|
| Topic 2 |
|
| Topic 3 |
|
| Topic 4 |
|
Get 100% Authentic Fortinet NSE6_FNC-7.2 Dumps with Correct Answers: https://www.dumpsvalid.com/NSE6_FNC-7.2-still-valid-exam.html
Accurate Hot Selling NSE6_FNC-7.2 Exam Dumps 2025 Newly Released: https://drive.google.com/open?id=1_HkEP_h4fVTs68tiKta3AURdqMjw-TG2